Gutter Installation & Repair
In Monroe, WA
New seamless gutters formed at the house and sized for Monroe's 51 inches of yearly rain, plus repairs, guards and fascia work. Every eave measured and the price in writing first.
In Monroe, new seamless aluminum gutters cost between $9 and $16 per foot installed in 2026, with 6-inch at the top of that range and 5-inch at the bottom. A typical two-story house runs $2,000 to $3,600, gutters only, with downspouts on top. If only one corner leaks or one run sags, a repair usually lands between $150 and $600. Monroe gets about 51 inches of rain a year, so most two-story homes here should get 6-inch gutters with 3x4-inch downspouts. We measure each eave before any work and put the price per foot in writing.
That rain figure isn't borrowed from Seattle. It comes from NOAA's weather station in Monroe, just over a mile from the middle of town, where the 1991 to 2020 normals average 50.77 inches a year. On the same normals, Renton's airport station averages 34.69 inches and Seattle's Sand Point station 37.82. Monroe also logs about 7.3 days a year with an inch of rain or more. Renton gets 3.8.
Plenty of Monroe houses are due for new gutters right about now. The Census Bureau's 2020 to 2024 estimates count 1,780 homes in the city built during the 1990s, more than in any other decade, and roughly seven in ten of Monroe's 6,367 housing units went up in 1990 or later. A seamless aluminum gutter is good for 20 to 30 years. A house finished in 1996 that still has its first gutters hits 30 this year.
Atrax Roof and Gutter was started by Danyllo Silva in Kirkland in 2018. Its Washington L&I contractor license is ATRAXRG824NU, the company is bonded and insured, and our own crews (no subcontractors) install and repair gutters across Monroe, fit guards and replace the soft fascia behind them. The 20-year workmanship warranty covers every new gutter system we install.
What gutters cost in Monroe in 2026
Installed prices for seamless aluminum, which is what goes on most of the houses we work on. Removing the old gutters is usually included when we replace them.
| Work | 2026 price | Typical Monroe use |
|---|---|---|
| New 6-inch seamless gutter | $11 to $16 per linear ft | The default on two-story homes and on big roofs that shed a lot of water |
| New 5-inch seamless gutter | $9 to $13 per linear ft | Single-story houses with short runs and open sky overhead |
| Downspouts | $4 to $7 per linear ft | Sized to match the gutter: 3x4-inch with 6-inch, one at each outlet |
| Seamless gutters and micro-mesh, installed together | $11 to $18 per linear ft | Lots with firs, cedars or maples over the roof |
| Micro-mesh guards on sound gutters | $4 to $8 per linear ft | Gutters that already drain properly |
| Repair visit | $150 to $600 | A dripping corner, a plugged outlet or one sagging run |
| Replacing one split or crushed length | $10 to $20 per linear ft | The rest of the run is still in good shape |
| Soft fascia board replaced | $300 to $800 for a typical section | Rotten trim found once the old gutter is off |
A worked example: picture a 1990s two-story in Monroe with 210 feet of eave and six downspouts about 18 feet tall. With 6-inch gutter, the 210 feet cost $2,310 to $3,360, and the 108 feet of downspout adds $432 to $756, so the total sits around $2,750 to $4,100 before any fascia work. The same house in 5-inch would be $1,890 to $2,730 for the runs.
Why Monroe gutters have to carry more water
Monroe sits at the foot of the Cascades, near where the Snoqualmie and Skykomish rivers join to form the Snohomish, and its rain gauge reads far wetter than the Renton and Sand Point figures above. On the station's 1991 to 2020 normals, October through January brings 25.49 inches, half the year's total. November is the wettest month at 7.16 inches, and it averages 1.5 days with at least an inch of rain.
An inch of rain on a 2,600 square foot roof is about 1,600 gallons, and every one of them has to get through the gutters and out the downspouts. A 5-inch system that coped fine in a drier town can spill along whole runs here. On most Monroe two-story homes we go with 6-inch K-style gutter, which moves about 40 percent more water than the 5-inch size, and 3x4-inch downspouts, which have twice the opening of a 2x3, and that matters when leaves wash down with the water. The math behind that choice is in our gutter sizing guide.
The city expects more, not less. Monroe's 2023 climate change analysis, written for its 2044 Comprehensive Plan, projects wetter winters and says heavy storms of the kind that come every two years could arrive about 9 percent more often by mid-century. Gutters hung this fall will still be up then, so we size them with that in mind.
Seamless gutter installation in Monroe
Seamless means each run is a single piece from corner to corner. The crew forms it from a coil of aluminum right at the house and cuts it to the exact length of the eave. Joints remain only at the corners and outlets. Sectional gutters have a joint every 10 feet or so, and those joints are where the leaks start. Most homes are done in one day.
A Monroe installation from us includes:
- taking down and hauling off the old gutters;
- a look at the fascia once the old gutters are off, with photos of any soft wood;
- hidden hangers screwed into sound wood, with each run pitched toward its outlet;
- downspouts matched to the gutter size, plus an outlet below each roof valley;
- a hose test of every run and downspout before the crew packs up.
You can pick 5-inch or 6-inch K-style in dozens of colors to match the trim. Profiles and color options are on our seamless gutter replacement page.
Fascia: the board behind the gutter
Fascia is the trim board that runs along the roof edge, and it's what the gutter hangers screw into. When a gutter overflows for years, water runs down the back of it and soaks that board until the wood goes soft. On a Monroe house from the 1990s the fascia has been holding hangers for about 30 years. In the older neighborhoods around Historic Downtown it can be much older than that: the Census counts 563 housing units in the city built in 1939 or earlier.
Signs the fascia needs work:
- paint peeling or blistering along the roof edge;
- wood that gives when you press it with a thumb;
- a gutter tipping forward or pulling away from the house;
- hanger screws or spikes backing out;
- dark streaks on the siding right under the gutter.
We check the fascia on every estimate and again when the old gutters come down. Soft sections get cut out and replaced, typically $300 to $800 per section, and the new gutter goes up on solid wood. Sound fascia stays. New gutters don't automatically mean new fascia.
Gutter guards and covers for Monroe homes
If firs, cedars or maples hang over your roof, guards are worth pricing. The kind we install is stainless micro-mesh: the screen is fine enough that needles and leaves stay on top while the rain drops through into the trough. Over gutters that already drain well it costs $4 to $8 a foot. Installed together with new seamless gutters it's $11 to $18 a foot, and a typical 150-foot retrofit comes to about $600 to $1,200.
Two cautions. A guard on a gutter that leaks or sags only hides the problem, so the gutter gets fixed first. And guarded gutters still need a short check once a year, because a film of pollen and maple seeds builds up on the mesh and slows the water. Our gutter guard installation page compares the guard types.
Where Monroe downspout water should go
A gutter only gets the water as far as the downspout. After that, the city has a firm rule. Monroe's public works standards say no connections from downspouts, gutters, footing drains or yard drains are allowed to the sanitary sewer, so roof water has to be led away from the house some other way, onto a splash block or into a proper storm drain line.
Ground conditions change across town. The 2044 Comprehensive Plan says the soils on the north and west edges of Monroe take in water slowly, which can send more of it across the surface, and it lists the land north of Woods Creek Road, from Oak Street to the city limits, among the city's known geologically hazardous areas. FEMA flood maps mark flood hazard areas along the Skykomish River, Woods Creek and Lake Tye.
On every estimate we send water down each downspout, the buried ones too, and tell you which outlets empty next to the foundation or toward a slope. If the fix means a new drain line on a hillside lot, check with the City of Monroe before anyone digs, since the city regulates work in those hazard areas.
Repair the old gutters or put up new ones
Repair is the better call when one spot is failing on a system that is otherwise straight and tight: a corner that drips, an outlet packed with leaves, a single run pulled loose. What a repair visit covers is on our gutter repair page. New gutters usually make more sense if:
- you're seeing the same drips or sags on more than one side of the house;
- the gutters are clean and still spill over whole runs in a normal Monroe rain;
- the aluminum itself is split or crushed, beyond what new sealant can fix;
- fascia on several sides has to be replaced, which means the gutters come off regardless;
- it's a two-story house from the 1990s still wearing its original 5-inch gutters.
How a Monroe gutter job runs
- A walk around the house. We measure each eave, note the roof valleys and look at the fascia from the ground and from the ladder.
- Water through every run. A hose shows where water stands, leaks or backs up, buried downspout lines included.
- One written price. Gutter size, color, downspouts, guards and any fascia work, priced per foot and in writing, with photos of the problem spots.
- Install day. The runs are formed in your driveway, hung on hidden hangers and pitched to the outlets.
- Last check. We flush the new system, haul away the old metal and clean up before we leave.
Gutter service across Monroe
Monroe was incorporated in 1902 and now has about 19,800 residents on roughly 6.4 square miles where US 2, SR 203 and SR 522 meet. We work all over the city: Historic Downtown and the older streets around it, West Monroe between US 2 and SR 522, the area around Lake Tye and the Fryelands, North Kelsey, the newer neighborhoods north of US 2, and the homes off Chain Lake Road and Woods Creek Road.
For roofing and the rest of our work in Monroe, see our Monroe service page. Other cities nearby have their own gutter pages: Bothell, Lynnwood, Redmond, Kirkland and Everett.
Monroe gutter installation and repair questions
How much does gutter installation cost in Monroe, WA?
Installed, new seamless aluminum gutters are $9 to $16 a foot in 2026: 6-inch runs $11 to $16 and 5-inch $9 to $13. Most two-story Monroe homes total $2,000 to $3,600 for the gutter runs; downspouts run another $4 to $7 per foot. Footage, gutter size and fascia condition decide where in that range you land.
What does gutter repair cost in Monroe?
Plan on $150 to $600 for most fixes in 2026. A plugged outlet cleared and resealed is $150 to $300, a dripping corner $150 to $350 and a sagging run rehung $200 to $450. A new piece to replace one split length is $10 to $20 a foot, and rotted fascia behind it adds $300 to $800.
Are seamless gutters worth it?
For most houses, yes. A seamless run has no joints between the corners, and joints are where sectional gutters usually start leaking. Ours are formed at the house to the exact length of each eave, cost $9 to $16 a foot installed in 2026 and can last 20 to 30 years. Our 20-year workmanship warranty covers each new seamless system.
Do you need to replace fascia when replacing gutters?
Only if it's damaged. We check the fascia when the old gutters come down. Sound boards stay, and soft or rotted sections are replaced, usually for $300 to $800 a section, so the new hangers bite into solid wood. Peeling paint, spongy spots and a gutter that tips forward are the usual signs of bad fascia.
Do gutter covers work in heavy rain?
Fine stainless micro-mesh lets rain through to the trough while leaves and needles stay on top. How well it keeps up in a downpour comes down to two things: whether the gutter under it is big enough for the roof, and whether the mesh is kept clean. We size the gutter first, and a quick rinse once a year keeps pollen and maple seeds from filming over the screen.
What size gutters do I need for my house?
With about 51 inches of rain a year in Monroe, most two-story houses here need 6-inch K-style gutter paired with 3x4-inch downspouts. The bigger trough holds roughly 40 percent more than 5-inch. A single-story house with short runs and few trees overhead can still do well with 5-inch, which saves about $2 to $3 a foot.
Where should downspouts drain in Monroe?
Away from the foundation and never into the sewer, since Monroe's public works standards don't allow downspout or gutter connections to sewers. A splash block or a proper storm drain line does the job. On a sloped lot, and especially in the hazard area north of Woods Creek Road, check with the city before adding a new drain line.
Book a Monroe gutter estimate
November, December and January are Monroe's three wettest months, and a gutter that's too small or hanging loose shows it in the first big storm. Book a free estimate from our contact page. We'll measure every eave, test the downspouts and send one written price, and nothing gets scheduled until you say yes. Larger jobs can be financed.
Gutters That Keep Up With Monroe Rain
We measure every eave, run water down every downspout and send one written price per foot, from Historic Downtown to the newer streets north of US 2.