Gutter Installation & Repair
In Edmonds, WA
New seamless gutters and repairs for Edmonds homes, from the Bowl up to Seaview. Every run gets measured and every downspout gets a hose test before we price the job.
New seamless aluminum gutters in Edmonds cost $9 to $16 per foot installed in 2026. For the gutter runs alone, budget $1,200 to $2,600 for a one-story house or $2,000 to $3,600 for a two-story, then add downspouts. Repairs on gutters that are still sound mostly run $150 to $600. Rainfall here is moderate by Puget Sound standards, but most of it comes in the wet half of the year, and plenty of Edmonds lots slope toward the water, so where each downspout empties gets as much thought as the gutter size. We hose-test every run and downspout before we write a price.
There's no long-term NOAA weather station inside Edmonds. The closest, at Paine Field about 7 miles north, averages 33.4 inches of precipitation a year on its 1991 to 2020 normals, and Seattle's Sand Point station, about 10 miles south, averages 37.8. At Paine Field, close to 70 percent of the year's total falls from October through March, and November is the wettest month at almost 5 inches. On a 1,500 square foot roof, that's roughly 4,600 gallons in a single month, arriving in the same weeks the maples let go of their leaves.
Edmonds houses skew mid-century. Census Bureau estimates for 2020 to 2024 put the city's median year built at 1974. The 1960s produced 4,845 of its 19,479 housing units, more than any other decade, and the three decades from 1950 through 1979 account for 10,651 of them, about 55 percent. Aluminum gutters last roughly 20 to 30 years, so on most of these homes the gutters up now are already a replacement set, and a set hung before about 2000 has reached that age.
Conditions shift from one part of town to the next. Down in the Bowl, older bungalows and mid-century houses take the marine air off Puget Sound. Seaview and Perrinville sit under more trees, so clogged gutters are the bigger worry there. Bluff and view lots catch more wind, and for gutters they add something else: a slope somewhere below the downspouts.
Danyllo Silva started Atrax Roof and Gutter in 2018, and the company is based in Kirkland. We're licensed in Washington (ATRAXRG824NU), bonded and insured, and every crew is our own, with no subcontractors on your house. A full gutter installation comes with our 20-year workmanship warranty, and repairs are guaranteed to solve the specific problem we were called for.
New gutter cost in Edmonds by type of house
Footage drives most of the price, and footage follows the house. These are 2026 installed prices for seamless aluminum, for the gutters alone. Removal and haul-away of the old system is usually included.
| House | Typical gutter length | Installed price (2026) |
|---|---|---|
| Small bungalow or cottage | 100 to 140 ft | $900 to $2,250 |
| One-story rambler | 130 to 160 ft | $1,200 to $2,600 |
| Split-level or split-entry | 150 to 200 ft | $1,700 to $3,400 |
| Two-story house | 200 to 260 ft | $2,000 to $3,600 |
| Large custom or rebuilt home with many valleys | Over 260 ft | By the foot, at the 6-inch rate |
A split-level costs more than its footage alone suggests, because the upper roof drains past the lower one and that adds corners and downspouts. On a big custom house, each valley needs its own outlet.
Per foot, figure $9 to $13 for 5-inch K-style and $11 to $16 for 6-inch, plus $4 to $7 a foot of downspout and $300 to $800 for each soft section of fascia found under the old gutters.
Say you own a 1960s split-level with 170 feet of eave and five downspouts that each drop about 14 feet. With 6-inch gutter the runs total $1,870 to $2,720, and the 70 feet of 3x4-inch downspout adds $280 to $490, for about $2,150 to $3,210 before any fascia work. If only one corner drips and everything else is tight, a repair is the cheaper call.
Gutter repairs on Edmonds homes
When the gutters themselves are still in good shape, fixing the one bad spot is usually the better spend. Typical 2026 prices:
- Outlet packed with needles or leaves. Dug out, flushed and resealed for $150 to $300.
- Dripping corner or seam. Resealed, or the corner piece replaced, for $150 to $350.
- Run pulling off the fascia. Reset on new hidden hangers, sloped back toward its outlet, for $200 to $450.
- Downspout backing up at the ground. We hose-test the buried line, then reseat or extend the downspout for $100 to $300. A broken pipe underground is a separate job.
- Crushed or split length. A matching length of seamless aluminum goes in for $10 to $20 a foot.
Replacing everything starts to win once the trouble spreads: leaks or sagging on several sides, old sectional gutters dripping at joint after joint, freshly cleaned runs that still spill over in a regular fall rain, or fascia so soft in so many spots that the repair would force the gutters off anyway. Our gutter repair page explains what's included in a repair visit.
Downspouts on sloped Edmonds lots
On a view lot, where the water lands is as important as the gutter that carries it. Everything the roof sheds comes out at a handful of points, and on a slope the wrong point can soak the bank below the house.
When Edmonds reviews a building project, its stormwater code (ECDC 18.30) asks for runoff, roof water included, to be infiltrated, dispersed or held on the lot wherever that's feasible without causing flooding or erosion. The methods it lists for roofs come from the state stormwater manual and include downspout infiltration, downspout dispersion through a splash block or gravel trench, and perforated stub-out connections. On lots inside the city's earth subsidence and landslide hazard areas or their buffers, the code requires a geotechnical engineer's design, analysis and report before runoff goes to an on-site system.
The state manual is careful about slopes too. It allows a splash block only where at least 50 feet of vegetated ground lies between the downspout and the downstream property line, building or slope steeper than 15 percent. Splash blocks and dispersion trenches shouldn't empty on or above a slope like that without a review by a licensed engineer.
Swapping gutters on an existing house normally doesn't trigger that review, but the lesson carries over. A new downspout belongs at the same drain point as the one it replaces, not at a fresh spot near the top of a bank. During the estimate we push water down each downspout, underground lines too, and show you where it surfaces. If a line heads toward a slope and nobody knows where it ends, check with the City of Edmonds before anyone changes it.
Needles, leaves and gutter guards
Where the trees are thick, fir and cedar needles land in gutters all year and maple leaves pile on top of them every fall. Needles are fine enough to get past coarse screens and firm enough to jam an outlet once they mat.
We install stainless micro-mesh guards, which hold needles on top while rain passes through. Adding mesh to gutters that already drain well costs $4 to $8 a foot, and new seamless gutters with mesh on the same visit cost $11 to $18 a foot. Mesh isn't maintenance-free: plan on one inspection a year. The guard styles are laid out on our gutter guard installation page, and if you'd rather keep cleaning, the gutter cleaning cost guide lays out what that runs.
5-inch or 6-inch gutters in Edmonds
A 5-inch K-style gutter is enough for a one-story rambler with short runs and open sky above it, and it costs $2 to $3 less per foot. Valleys, long runs, an upper roof spilling onto a lower one or trees overhead all point to 6-inch, paired with 3x4-inch downspouts. Capacity goes up by about 40 percent with the wider trough, and a 3x4 outlet passes a wad of needles that would stop a 2x3. Space downspouts roughly 30 to 40 feet apart, and add one where a valley dumps into a run.
The numbers behind those rules are in our gutter sizing guide. For colors and gutter profiles, see the seamless gutter replacement page.
The fascia behind Edmonds gutters
Every hanger screws into the fascia, the board along the roof edge. On a house from the 1950s or 1960s, that board may already have held more than one set of gutters, and years of spillover rot it from the back, out of sight. Peeling paint along the eave, screws that spin without biting and a gutter tipping outward are the usual clues.
Fascia gets checked twice: during the estimate, and again when the old gutters are off and the whole board is visible. We cut out and replace the rotten lengths only, usually $300 to $800 apiece, and keep any board that is still firm, so each new hanger goes into solid wood.
How an Edmonds gutter installation goes
- Measure and look. We measure every eave, note where valleys and upper roofs drop water, and check the fascia from a ladder.
- Water test. We run a hose through each gutter and down each downspout, underground lines too, looking for leaks, backups and the point where the water comes out.
- One written price. Gutter size, color, downspout layout, guards and any fascia work, with photos of what we found.
- Install day. The old gutters come down, and new seamless runs are formed on site from a coil, hung on hidden hangers, and sloped to drain toward each outlet. Most houses are finished in a day.
- Final check. We run water through the finished system, load the old metal onto the truck and walk around the house with you.
Gutter service across Edmonds
Edmonds covers about 8.9 square miles of land on Puget Sound, and roughly 42,700 people live there, per the Census Bureau's 2020 to 2024 estimates. We work all over town, including Firdale, Westgate, Perrinville, Five Corners, Seaview and downtown Edmonds.
Roof work in Edmonds is covered on our Edmonds service page. Next door, Lynnwood has its own gutter installation page, and so does Bothell, farther east. For homes just south of Edmonds, see our page on gutter repair in Shoreline.
Common questions about gutters in Edmonds
How much does gutter installation cost in Edmonds?
Seamless aluminum gutters run $9 to $16 per foot installed in 2026, with 5-inch at $9 to $13 a foot and 6-inch at $11 to $16. Gutters alone on a one-story house typically total $1,200 to $2,600; on a two-story, $2,000 to $3,600. Downspouts add $4 to $7 a foot, and soft fascia $300 to $800 per section.
What does gutter repair cost in Edmonds?
Most repairs fall between $150 and $600. A plugged outlet cleared and resealed costs $150 to $300, a dripping corner resealed $150 to $350, and a sagging run reset on new hangers $200 to $450. Replacing one damaged length costs $10 to $20 a foot.
How much does it cost to add or replace a downspout?
A 3x4-inch downspout costs $4 to $7 per foot installed, so a 10-foot drop on a one-story house is about $40 to $70 and an 18-foot drop on a two-story about $72 to $126. On a sloped lot, placement matters more than price: a new downspout should drain where the old one did, or somewhere that carries the water away from the house and away from any bank.
Are gutter guards worth it in Edmonds?
Under fir, cedar or maple, usually yes. Stainless micro-mesh keeps needles and leaves on top while rain gets through, and on sound gutters that already drain, mesh runs $4 to $8 a foot. Under open sky, a cleaning or two a year may cost less. Guards still need a yearly check.
Where should downspouts drain on a sloped Edmonds lot?
Away from the foundation and away from the top of any bank. The state stormwater manual Edmonds builds on allows a splash block only with at least 50 feet of vegetated ground before a slope steeper than 15 percent, and on building projects in its landslide hazard areas the city requires a geotechnical engineer's design for on-site drainage. Keep new downspouts where the old ones drained.
Do Edmonds homes need 5-inch or 6-inch gutters?
For two-story homes, roofs with valleys and lots under trees, choose 6-inch gutter with 3x4-inch downspouts; it carries roughly 40 percent more water. A one-story rambler with short runs and few trees nearby does fine with 5-inch, which saves $2 to $3 on every foot.
How long does a gutter installation take?
Most houses are done in one day. The crew takes the old gutters down, checks the fascia, forms the seamless runs on site, hangs them and runs water through the system before leaving. Larger homes or a lot of fascia repair can take longer.
Book an Edmonds gutter estimate
November is the wettest month at Paine Field, the closest long-term weather station, and a gutter that can't keep up tends to give itself away the first time it pours for a whole day. The quickest way to book a free estimate is our contact page. We'll measure, test every downspout and send one written price, and nothing goes on the schedule until you say yes. Larger projects can be financed.
Gutters Built For Edmonds Winters
We measure every eave, run a hose through every downspout and send one written price, in Firdale, Westgate, Perrinville, Five Corners and the Bowl.